So I have a curing oven and have replaced the switch and control panel but it is not heating up. Any ideas
Like
Comments (8)
You can see on the left side of this paper the ink stops appruptly. Why?!?!? It was to finish printing the rest of the card.
top of page
DTF Questions & Answers
All DTF Questions & Answers, be sure to mention your printer model, and any RIP software you are using.
DTF PRINTING SUPPORT
Like
Comments (17)
SuperTech220
Dec 08, 2022
scale the image down in the print dialogue when sending to print, or choose "fit on page" option when setting up the print, see if that helps. Otherwise you will need to open the original artwork file, and center the artwork on the page then save as a PDF again
1
Find them here:
https://www.inkdropprinterservices.com/free-printer-service-manuals/
Like
Comments (1)
Wondering which system everyone is buying and their experiences with them?
Like
Comments (1)
Unknown member
Nov 29, 2022
I two systems DTF systems here at the shop and honestly they are both working well (L1800 and R1390).....I wish the R1390 was a bit faster though....what are you printing with?
Like
We are looking for someone that was some guidance on this issue. Everything, nozzle checks, clean encoder strip, clean wiper blade, perfect humidity) is passing the test but we are still having lines or banding in our dtf prints. We have been working with Ricoh but they are at a loss.
Like
Comments (3)
Unknown member
Nov 29, 2022
We also have that Service Manual available for download on the site
https://www.inkdropprinterservices.com/ricoh-service-manuals
Like
Unknown member
Nov 29, 2022
If the nozzle tests are good, and the banding only happens a few prints into the production run, then that indicates an possible damper issue, or ink flow issue of some sort.
Inspect the ink lines for air bubbles , or any signs of air contamination.
post some pics of…
Like
Unknown member
Nov 29, 2022
Kristi,
How many prints into the run are you getting before you start seeing the banding (1 shirt,2 shirts...etc?)
And what color is banding?
Can you post some pics?
Like
bottom of page
I also STRONGLY suggest getting a "Step Up Power Converter" from 110-220 that can handle atleast 200 amps.
This is the one that I have and it was a bundle with my printer. It just quit heating. It comes on I went though steps to reset it and it didn’t work.