You can see on the left side of this paper the ink stops appruptly. Why?!?!? It was to finish printing the rest of the card.
top of page
To see this working, head to your live site.
Cannon MG2522 cutting off when printing pdf (left side)
Cannon MG2522 cutting off when printing pdf (left side)
17 answers0 replies
Like
Comments (17)
Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page
Try that PDF
scale the image down in the print dialogue when sending to print, or choose "fit on page" option when setting up the print, see if that helps. Otherwise you will need to open the original artwork file, and center the artwork on the page then save as a PDF again
Look at the left side...you can see it is off exactly the amount that your print is off
Ok, I can see in the PDF quick view that the artwork is not centered on the PDF page.
It won't let me link the page, copy and paste the address below into your browser:
https://ij.manual.canon/ij/webmanual/PrinterDriver/W/MG2500%20series/1.0/EN/PPG/Dg-pagesetup.html
That will take you into instructions for setting up page correctly in the Cannon print dialogue. Let us know if it helps.
https://ij.manual.canon/ij/webmanual/PrinterDriver/W/MG2500%20series/1.0/EN/PPG/Dg-pagesetup.html
https://ij.manual.canon/ij/webmanual/PrinterDriver/W/MG2500%20series/1.0/EN/PPG/Dg-pagesetup.html
The link below takes you to instructions on how to set up your page when printing on your system, look it over and see if it helps.
I'm assuming that you are opening the PDF and sending straight to print ?
double check that the artwork is centered correctly on the PDF page.
Double check that the card is the same size as the PDF page.
Double check that you don't have any offsets set up in the print dialogue when you send it to print.
After looking closer it appears that your design isn't centered correctly on the page. It sounds like you a finished PDF that is set up for print.
It's possible that
The artwork isn't centered on the PDF page
you have offsets designated in your print set up
Cn you send a screen shot of the actual design? I want to see what isn't printing?