3.15A ceramic fuse used in a variety of printers including DTF and DTG printers. Fast blow 3.15A ceramic fuse will keep your printer electrical components safe from electrical shorts that could cause damage to printheads & electronic boards. The 3.15A ceramic fuse can typically be replaced with needle nose pliers.

3.15A Ceramic Fuse | Fast Blow Surface Mount Safety Fuse

$5.00

Quantity

3.15mA ceramic fuse
Our suggestions to insure that the fuse doesn't blow during electrical repairs are:

Power your printer off.

Disconnect the power cable from the system.

After you have disconnected power to the printer and the main power cable, push the power button a few times to clear any residual electricity that will be in the system.

Then remove the fuses from the mainboard before changing cables or doing any electrical troubleshooting.